abrasive material
英 [əˈbreɪsɪv məˈtɪəriəl]
美 [əˈbreɪsɪv məˈtɪriəl]
磨料
英英释义
noun
双语例句
- On the basis of the characteristics of the lubrication film, surface texture, abrasive particle material and work conditions, it sets up the wear rate analysis calculation formula of piston ring and cylinder liner.
本文在考虑了油膜特性、形貌特性、磨粒特性、材料特性及工况条件等因素的基础上，导出了活塞环&缸套的三体磨粒磨损分析计算公式。 - The test results show that wear resistance of tested steel under low stress abrasive depends on material hardness. Wear resistance of quenched microstructure is highest.
结果表明：低应力磨粒磨损的耐磨性主要取决于材料的硬度，淬火态组织的耐磨性最好。 - According to the working condition of high temperature and abrasive wear, the material structure and composition of the wear-resistant and heat-resistant steel are designed.
根据在高温氧化性气氛下磨料磨损的工况条件，合理设计了抗磨耐热钢材料的组织和化学成分。 - For the two kinds of abrasive grain& ordinary abrasive and ultra hard material, carborundum and diamond were chosen as samples for dispersing experiment.
针对两大类磨料微粉&普通磨料和超硬材料，选择碳化硅和金刚石为例进行分散实验。 - Silicon carbide ( SiC) powder, as the abrasive material or the stuffing, has the extensive application in vitrified bonded abrasive product, resin bonded polishing wheel and in diamond polishing wheel.
碳化硅（SiC）微粉作为磨料或填料在陶瓷精磨磨具、树脂抛光砂轮以及金刚石抛光砂轮等方面有着广泛的应用。 - Abrasive material used for on-site surface pretreatment of pipeline corrosion protection joint
管道防腐补口现场表面预处理用磨料 - Some measures to accelerate vegetation restoration are proposed in accordance with the regulation on vegetation succession and characteristics of abrasive material.
针对植被演替规律和剥离物特性提出快速恢复植被相应对策。 - With the orthogonal tests the influence of work condition of the 3-phase abrasive water jet to material removal and erosion depth is analyzed, and the relationship between the abrasive granularity and the surface roughness is discussed.
通过正交试验，分析了三相射流工作条件对材料去除量和冲蚀深度的影响，讨论了磨料粒度与加工表面粗糙度的关系。 - In terms of pre concentration strengthening, more crushing and less grinding, abrasive resistant material usage and classification intensification, the paper describes the present situation of grinding classification both in and outside China and discusses on the development orientation of grinding classification in China's metallurgical mines.
本文从强化预选、多碎少磨、应用耐磨材料和强化分级三个方面论述了国内外磨矿分级的现状，探讨了我国冶金矿山磨矿分级的发展方向。 - Design of PLC Control System of a Deburring Equipment with Abrasive Material
一种磨料刷去毛刺设备的PLC控制系统设计